API 653 Exam Chapter 16

1.

Q1. ASME Section V Article 2: radiography T-223
When performing a radiograph, where is the ‘backscatter indicator’ lead letter ‘B’ placed?

2.

Q2. ASME Section V Article 2: radiography T-277.1 (d)
Wire IQIs must be placed so that they are:

3.

Q3. ASME Section V Article 6: penetrant testing T-620
Liquid penetrant testing can be used to detect:

4.

Q4. ASME section V article 1: T-150
When an examination of the requirements of section V is required by a code such as API 650 the responsibility for establishing NDE procedures lies with:

5.

Q5. ASME Section V Article 6: penetrant testing mandatory appendix II
Penetrant materials must be checked for which of the following contaminants when used on austenitic stainless steels?

6.

16.8 ASME V articles 7 and 23: familiarization
questions

Q1. ASME Section V Article 7: magnetic particle testing T-720
Magnetic particle testing can be used to find:

7.

Q2. ASME Section V Article 7: magnetic particle testing T-720
During an MT procedure, maximum sensitivity for finding discontinuities will be achieved if:

8.

Q3. ASME Section V Article 7: magnetic particle testing T-741.1 (b)
Surfaces must be cleaned of all extraneous matter prior to magnetic testing. How far back must adjacent surfaces to the area of interest be cleaned?

9.

Q4. ASME Section V Article 7: magnetic particle testing T-741.1 (d)
According to ASME V, what is the maximum coating thickness permitted on an area to be examined by MT?

10.

Q5. ASME Section V Article 7: magnetic particle testing T-764.1
Which of the following methods can verify the adequacy of magnetic field strength?

11.

Q6. ASME Section V Article 7: magnetic particle testing T-762(c)
What is the lifting power required of a DC electromagnet or permanent magnet yoke?

12.

Q7. ASME Section V Article 7: magnetic particle testing T-752.2
Which types of magnetizing current can be used with the prod technique?

13.

Q8. ASME Section V Article 7: magnetic particle testing T-752.3
What is the maximum prod spacing permitted by ASME V?

14.

Q9. ASME Section V Article 7: magnetic particle testing T-755.1
What is the best description of the limitations of yoke techniques?

15.

Q10. ASME Section V Article 7: magnetic particle testing, appendix 1
Which MT technique is specified in ASME article 7 mandatory appendix 1 to be used to test coated ferritic materials?

16.

Q11. ASME Section V Article 23: ultrasonic thickness testing, section 5.1
UT thickness checking using standard equipment is used for temperatures up to:

17.

Q12. ASME Section V Article 23: ultrasonic thickness testing, section 8.5
Special ultrasonic thickness measurement equipment can be used at high temperatures. If the equipment is calibrated at ambient temperature, the apparent thickness reading displayed at an elevated temperature should be: